HAF 912 Interior Design

Unlike some of the contempo Libation Master example models like the HAF 932 Black and 922 Blood-red, the 912 is not color-matched on the inside of the chassis. Leaving the chassis the basic battleship grey likely helps keep costs down.

The power supply opening is located at the bottom of the chassis, with four rubber bumpers to elevate the PSU slightly then that information technology does not sit apartment against the panel. A vented department is provided to allow PSU fans to draw air from under the case. Riser carte du jour slots have removable blanks held in with traditional screws. There's the vii standard ATX format plus one additional overhead. The provided 120mm exhaust fan has a three-pin ability connector with a four-pin Molex adapter to allow for either blazon of connection.

An oversized cutout in the motherboard tray gives access to the underside of the lath once installed to allow for backplate changes without having to remove it. As mentioned previously, the raised section in the top panel holds either a unmarried 200mm fan or two 120mm fans, neither of which is provided.

Of the four 5¼" external trophy found in the HAF 912, only the height one has a tool-less blazon of latching mechanism. Although not the traditional Cooler Master style button-push lock institute in their other HAF cases, the sliding lever works just as smoothly. The three lower drive cages provide room for 4 3.v" drives plus ii more 3.5" and two ii.5" drives. Both the top 3.v" and the two.5" cages are easily removable if you run out of space.

The lower three.5" cage is held in with rivets which would crave drilling. The iii.five" drive trophy all apply snap-on plastic runway for mounting, not the usual latching drive trays, but again just as like shooting fish in a barrel to utilise.

The front end bezel is held on with a series of clips running down each side. There are no wires running from the console to the within; all of the electronics are housed in the upper top section of the example. The 4 5¼" bays all have mesh filler panels that snap out easily from the rear, and the lower section has a removable mesh filter fastened. A single 120mm intake fan comes with the HAF 912, although at that place is room for a second, plus the pick to utilize a single 200mm instead.

The accessory box contains snap-on rails for 3.5" drive mounting, 5¼" to 3½" bay adapter metal plates, a 3.5" to two.5" plastic adapter, and plenty of mounting hardware and zip ties to install all your components and keep wiring tidy. Speaking of hardware let's get some installed into the HAF 912.